-15%
HP-25 PREHEATING FURNACE
Specially designed for heating cylinders and crucibles. Stainless steel housing. Ceramic muffle. Various models available.
Advantages:
- Control panel allows the operator to program a sequence of pre-established times and temperatures.
- Memory can store up to 20 different programs.
- End of cycle buzzer.
- A buzzer sounds when door is open.
- Thermocouple fail detection system.
Details:
- Maximum temperature: 1110°C; maximum time: 99 hours 59 minutes. Can be programmed in °C per minute.
- Heating elements on all internal sides guarantee uniform temperature distribution.
- Both the air vent on the door and the rear ventilation tube have calibrated sections. These features refresh the air in the unit without reducing thermal output or causing temperature differences in the muffle.
- Equipped with a power supply that enables an extraction unit to be used with the furnace.
- Magnetic door closure.
Note:
If the temperature display starts flashing a value of 1200°C during normal furnace operation, then disconnect the unit from the main power supply because the thermocouple is damaged. The thermocouple is subject to wear and its durability depends on the operating temperature. This component is not covered by the warranty.
Technical data:
Mains input: 230V
Power: 1,500W
Capacity: 2.7l
Maximum temperature: 1.100ºC
Flask dimensions: 10cm (height) x 16cm (width) x 16.5cm (depth)
Vent hose: Ø 38 mm
Dimensions: 46.5cm (height) x 33.5cm (width) x 34cm (depth)
Weight: 30kg
Accessories:
H100433 Smoke catalytic converter.
H92225 Smoke extractor.