-15%
SMALL MINI MOLD KIT FOR BONDING RETENTION WIRE
LARGE MINI MOLD KIT FOR BONDING RETENTION WIRE
MINI MOLD KIT FOR LINGUAL BUTTONS
MINI MOLD KIT FOR MAKING BRACKETS
MINI MOLD KIT FOR HABIT CONTROL
MINI MOLD KIT FOR BITE CORRECTION
MINI-MOLD BITE RAMP 5MM KIT
FLEXIBILITY. UTILITY. VERSATILITY. AVAILABILITY. You will always have buttons and other accessories available using the light-bond adhesive. For Lingual Buttons, Bonding Retention Wires, Bite Correction, Habit Control and Emergency Brackets. Instructions for use for the different molds available: Etch and prepare the surface of the tooth according the adhesive manufacturer's instructions. Then, follow the following instructions according to the mold that you wish to use. 1. Measure the length of the wire that you want to use, cut and have it prepared. 2. Insert the mold in order to bond the wires in the handle. 3. Fill the mold with the Photocurable adhesive. 4. Position the wire over the teeth and place the mold over the wire so that the wire enters the slot. First start with the most central teeth and then proceed distally. 5. Light-cure with the lamp between 5 and 20 seconds according to the type of lamp you are using. 6. Remove the mold slowly. 7. There are two size mold for bonding wires. 8. For use with wires up to .020'.
Downloads